Firstly, in insulation engineering, new materials, processes, and structures should be used as much as possible. At the same time, economic comparison and analysis should be conducted during the material selection process. Insulation materials with good insulation effect, high performance, reasonable price, and easy construction should be used to save resources as much as possible; Secondly, when calculating the thickness of the insulation layer, reasonable exploration and improvement should be made to the parameters in the calculation methods and methods. The thermal conductivity coefficient should be scientifically determined to avoid surface temperature exceeding a reasonable range. The physical and chemical performance indicators of materials should be tested by national authoritative institutions; Thirdly, the design department and personnel should have a thorough understanding and mastery of the problems that exist on the construction site, and pay attention to the feedback information from the construction and make timely improvements; Fourthly, in the design process, corresponding new processes should be adopted based on the properties of new materials, and reasonable improvements should be made to outdated or unsuitable structures, in order to develop a new scientific structure; Fifthly, based on the actual engineering situation, comprehensive consideration should be given to the structure and material selection of certain equipment, not only to ensure the appearance is beautiful, but also to ensure the insulation effect; Sixth, due to the special properties of some furnace walls, semi hard materials should be used as much as possible for insulation, and soft or brittle materials should not be used; Seventh, for thermal equipment and pipes subject to frequent vibration at high temperature, microporous silicic acid insulation materials should not be used. When elastic soft materials, such as foam asbestos, are used for retaining walls, the thickness of the insulation layer needs to consider the compression properties of the materials. The corners of the protective wall can be directly wrapped; Eighth, for certain equipment, such as air ducts, smoke ducts, etc., due to their density and high reinforcement bars, when the thickness of the insulation layer is thin, materials with less elasticity and soft texture should be used. When the insulation thickness is thick, hard or semi hard materials can be used internally, and soft materials can be used externally; Ninth, strictly control the quality of materials, prioritize the use of materials for public bidding, and relevant leaders should scientifically and reasonably reduce administrative intervention; Tenth, materials need to be inspected in batches and carefully accepted. Materials that fail the inspection are strictly prohibited from being used; Eleventh, measures should be taken above the material to prevent rain and snow from affecting the insulation effect due to moisture; Twelfth, according to the characteristics of insulation engineering, it is necessary to increase the supervision of intermediate links, strictly control the quality, and reasonably coordinate the construction materials, construction, and construction supervision.
Contact me:Email:wp@cnjingganrefractory.com/sdwenping@163.com
TEL: 86-0533-4188518 / FAX: 86-0533-4188518
Rose:+86-13275332819(wechat/whatsapp number)
