Home > News > Content

What Steps Are Required For Magnesia Refractory Brick Masonry?

Jun 05, 2023

Magnesia Refractory Brick have high fire resistance, good alkali resistance slag performance, high starting temperature for load softening, but poor thermal shock resistance. Sintered magnesia bricks are made from magnesia bricks as raw materials, which are crushed, batched, mixed, and shaped before being fired at a high temperature of 1550-1600 ℃. The firing temperature of high-purity products is above 1750 ℃. Non poured magnesia bricks are made by adding appropriate chemical binders to magnesia sand, mixing, shaping, and drying. Based on the experience in producing magnesium bricks, the magnesia brick company has made the following regulations for refractory brick masonry in order to fully utilize the efficiency of kiln lining materials, ensure the service life of kiln lining materials, and extend their service life:

1. Carefully clean the dust and debris on the inner wall of the kiln shell; Magnesia Refractory Brick

2. The inside of the kiln shell should be flat and free from unevenness+

3. The mortar joint between magnesium bricks should be controlled between 1.5mm and 2mm;

4. The application of adhesive should be uniform and full, without any lack of slurry. Evenly apply the adhesive and rub it with masonry to allow for a slight extrusion of the adhesive;

5. The masonry of the kiln lining should be flat and free from staggered platforms. Efforts should be made to avoid common problems such as misalignment, tilting, uneven mortar joints, misalignment, double joints, through joints, opening, void, rough joints, serpentine bends, masonry bulging, and mixing;

6. The expansion joints in the refractory brick lining must be reserved according to the design and must not be omitted;

7. The lining of important and complex parts of magnesium bricks should be pre laid first;

8. The locking seam should be firm. When processing refractory bricks, a brick cutting machine should be used for fine processing of the bricks, and manual processing of the bricks is not allowed; The sealing bricks of magnesium bricks in the rotary kiln and under the supporting brick board should not be less than 70% of the original bricks; In flat joint bricks and curved bricks, it shall not be less than half of the original bricks. The opening must be locked with original bricks. The processing surface of bricks should not face towards the inner side of the furnace.

Send Inquiry