Operation steps of carburizing agent for steelmaking
1. If the temperature of the steel-making furnace reaches the specified temperature, there should be two or three minutes of time for heat insulation, heat preservation and carburizing agent. Remember that you can't immediately remove the slag and water. Because the carburizing agent is lighter than the steel-making furnace, it's very easy to raise it on the surface of the steel-making furnace
2. If the slag is removed immediately, the surface layer of the carburizer will be mixed in the coal ash and exposed together, which will be a serious waste of the carburizer. In addition, it will harm the practical effect of the application of high sulfur carburizer.
3. In addition, pay attention to the usage of carburizing agent, and add graphitized carburizing agent according to the carbon element that is missing, not too much or too little.
In the actual operation of the carburizer, we must grasp the addition time and amount of the carburizer. In addition, the actual operation of the carburizer must be appropriate, so as to avoid the problems in the whole application process of the carburizer.
